THE HIMMER MILL SENT TO INDIA 

Hammer mill Features: 

1. The base of the hammer mill is 10mm thick, and the steel plate is bent and reinforced, and the box plate is made of 16mm thick steel plate Q235 

2. The motor adopts Shandong Luhong brand, CE certified brand, 90kw-4-B3 

3. The main material of the hammer is 65 manganese plate, tungsten carbide welding material, high wear-resistant material 

4. The sieve of the hammer mill is processed by punching 65 manganese steel plates 

5. The diameter of the rotor is 650mm, and the diameter of the rotor disk is 425mm, which is laser processed from No. 45 steel plate 

6. Double φ273 screw conveyor 

7. The 42-hole pulse dust collector must be equipped with an air pump 

8. The belt conveyor is made of galvanized steel plate with a thickness of 3mm and the surface is corrosion-resistant 

9. The belt material is a 3-layer rubber belt with good toughness 

10. The electrical components adopt the Delixi brand, and the host is started by a soft starter. 

11. The control unit can keep the machine running normally. When the current is high, the feeding stops, and when the current is low, the feeding starts. The control unit performs automatic control without manual control, which can save labor and increase production 

12. The bearing is 2316C3 model, high speed, quiet, Harbin bearing brand 

13. Easy installation, time-saving and labor-saving, simple operation, low failure rate, etc.

The base of the hammer mill is 10mm thick, and the steel plate is bent and reinforced, and the box plate is made of 16mm thick steel plate Q235

The motor adopts Shandong Luhong brand, CE certified brand, 90kw-4-B3

The main material of the hammer is 65 manganese plate, tungsten carbide welding material, high wear-resistant material

The sieve of the hammer mill is processed by punching 65 manganese steel plates